The Deck Cable Rail Heritage Series WiseRail Accessory is a budget-friendly cable railing kit for any wood post as an outside-to-outside fitting on a straight level run or a pitch or stairs.

The tensioning device is a 2-7/8” long threaded stud installed on the back of one end post. A pull lock fitting is established through the other end.

This through-the-post configuration is the only scenario in which the economical threaded stud kits may be used. These threaded stud kits are more economical than the WiseCable® Estate WC-ES Series. 

Still, the threaded studs are an essential, functional fitting, not a hide-in-the-post solution. A brass hex nut and some metal thread will extend beyond the back of the post on one end. (Brass hex nut end cap sold separately.)

Use the WiseCable® Heritage WC-HS Series for decks with dedicated end posts for each run where the posts are situated such that the back sides of the posts are all accessible. Meaning you can use a through-the-post configuration.

This is the most economical solution and where the fittings are least visible.

When taking the WiseCable® Heritage WC-HS Series cable railing through a corner, do not bend the cable past 45⁰ at any time. If turning 90⁰, a 2-step turn using a double corner post configuration is required, as illustrated in the corner post instructions.

Tools needed for WiseCable^® Heritage WC-HS Series on level straight runs:

• 5/32 drill bit
• 9/32 drill bit for threaded stud installation
• 29/64 drill bit for pull lock installation
• 7/32 wrench for holding the stud
• 7/16 wrench for tightening jam nuts
• Cable cutting tool
• If using post protector tubes, 1/4 drill bit